Epson installation configuration and connections – Epson 7300 User Manual
Page 2
Page 2
Extron • System 8/10 P
LUS
• User’s Manual • P/N 68-424-01 Rev. D
Epson Installation
Configuration and Connections
Epson 5300/7250/7300 Projector Configuration
Verify that the System 8/10 P
LUS
is already configured for the Epson 5300/7300
projector. The general setup is explained on page 3-4 and the switch settings for
the projector are repeated below.
1. Use a small screwdriver to remove the access cover from the System 8/10 P
LUS
front panel. See bottom of page 3-3. The label on the back of the access cover
also has the configuration information.
__________ Before changing anything, remove the AC power cord to the System 8/10 P
LUS
to verify that the main power is OFF; also turn the projector power OFF.
2. Set the switches as follows:
Config
Model
Rotary Switches Cable
SW15 Settings
Comm
as
RS1 RS2 RS3 RS4 J2/J3
1 2
3
4
5
6
7
8
9 10
Adapter
✔
Epson 5300
0
0
E
2
J2
↓ ↓ ↑ ↓ ↑ ↓ ↓ ↓ ↑ ↓
26-484-01
✔
Epson 7300
0
0
E
2
J2
↓ ↓ ↑ ↓ ↑ ↓ ↓ ↓ ↑ ↓
26-484-01
_ RS5 is for RGB switching
delay. See page 3-4 for
more information on switch
functions.
3. Use a grease pencil (or other rub-off marker) to mark the space on the label next
to “Epson 5300/7300”.
4. Locate the switcher’s Address DIP switches on the rear panel, lower right.
Unless this is part of a master/slave system, set #3 and #5 to the up position and
the others down. See illustration to the left.
Use the illustration on the facing page to do the following steps.
5. Connect the projector’s Com cable to the Com 1 DIN connector of the projector.
6. Connect the Comm Adapter’s 9-pin female connector to the 9-pin male
connector of the projector cable. Connect the other end of the Comm Adapter to
the Communications extension cable (CC-50' or CC-100').
7. Connect the CC cable to the 15-pin HD “Projector Control” port located on the
rear panel of the System 8/10 P
LUS
.
______ Secure the screws on all D connectors.
8. Connect the BNC (RGBS) cables from the System 8/10 P
LUS
outputs to the
Epson projector inputs according to the application requirements.
9. Apply Main Power to the System 8/10 P
LUS
by connecting the power cord. The
Main Power LED should light. Apply power to the projector.
Configured For:
RS-232
3
4
5
6
7
8
9
10
1
2
SW15 DIP Switch
ON
RS5 RS2
RS2
RS1
RS3
RS4
RS1
RS3 RS4