Epson 7300 - Manual (Page 3)

Page 3 Extron • System 8/10 P
LUS
• User’s Manual • P/N 68-424-01 Rev. D
Epson Installation Configuration and Connections
10. Power on the projector with either the remote control or by pressing the
projector’s power button.
11. Press the projector’s Menu button, then select Options and enter this selection.
12. Select Mouse/Com 1, then select BNC Format RGB and enter this selection.
_ When the projector and switcher are communicating with each other, there will be a delay of
30 to 60 seconds when powering the projector on/off using the System 8/10 Plus.
Epson 5300/7300 Projector Connections
Use the illustration below when connecting the System 8/10 P LUS to an Epson
5300/7300 projector. Refer to Epson documentation to continue the installation.
_ You cannot input S-video and Composite video sources simultaneously
_ If the installation includes looping (master/slave) switchers, see Chapter 5.
If Video Loop Back is part of the installation, see pages 2-10 and 2-11.
15-Pin HD
CC 50'
Comm
Adapter
26-484-01
"I"
9-Pin
"I"
Male
9-Pin
3, 4 or 5 BNC
See note
below
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○