Epson R1800 User Manual
Page 7
5
Fix the angled tube support as shown.
The sticky pad is face down with the
clear tube furthest away from the angle.
This support needs to be 250mm away
from the yellow cartridge. The support
easily slides along the tube for
positioning.
Use a marker to identify the position of
the finished tube support. From the edge
of the opening to the first mark is 90mm
and 200mm to the second mark.
Assemble the tube support as shown and
remove the three pieces of backing tape
from the double sided tape.
Position the tube support as shown
between the two marks made previously
(the 90 and 200mm).
Take off the backing tape and position
the small tube clamp on the right of the
printer housing and slide the tube into the
clip.
After feeding the cartridges all the way
through the housing, lay them out of the
way on top of the printer
Slide the printhead back to the cartridge
removal position…...
….remove the elastic band and place the
cartridges into their relevant colour slots.
DO NOT PUSH THEM DOWN YET
Slowly lay the bottles down as shown
and stand them back up after 2-3
seconds. This self levels the ink in the
small chambers.
Do Not Raise Bottles Higher Than
The Printer. Remove the rubber
stoppers……..
...and fit the air filters.