EdgeStar CWR265SZ - Manual (Page 7)

6
Temperature Control
Front panel controls
Using the controls:
Use the left side controls to adjust the temperature. The
temperature displayed will be in Fahrenheit. This wine cooler has
an actual temperature range from 50°F to 56°F. Whether your wine
cooler can reach the actual set temperature depends on the
ambient environmental conditions.
Press the button on the left side of the control panel to lower the
temperature by 1 degree increments. The set temperature will flash
for a few seconds, and then revert to the ambient inner temperature
of the wine cooler.
Allow at least 24 hours for the temperature to acclimate, and before
storing your wines.
Press the button on the left side of the control panel to increase
the temperature by 1 degree increments.
Press the button to turn on and off the inner light.
When the temperature of the unit becomes too low, the LED will
display “LL”, likewise, when the temperature is too high, it will
display “HH”. The unit will display “ER” in the event of an error or
power disruption.
Tip: To conserve energy, always set the display above 48;
otherwise, the inner fans will run continuously.
Note: The right side controls will have little or no bearing on the
inner temperature. It is recommended you set the right LCD at 55.
Important Note: This unit will operate best in a room with a
temperature less than 90°F (32°C).
Light Button
Up and Down Buttons
LCD Display
Please note that the front
panel controls will allow you
to change the temperature
to a range that is higher and
lower than 50-56°F;
however, the unit is
designed to only achieve
temperatures between 50-
56°F.