Epson Pro Mac ES-1200C - Manual (Page 7)

Connecting the Scanner to Your
Macintosh
Use this procedure to connect the scanner directly to the SCSI
port on your computer using the SCSI cable included with the
scanner. This cable has a 25-pin connector on one end and a
50-pin connector on the other.
If you are already using the SCSI port on your computer for
another SCSI device, such as an external hard disk, you need a
SCSI cable with a 50-pin connector on both ends. You can then
connect the scanner to your other SCSI device, following the
instructions in Chapter 1 of your ES-1200C User’s Guide.
Caution:
Be sure that your Macintosh, scanner, and any other SCSI
devices are turned off before you plug in the cable.
1. Plug the 25-pin connector into the SCSI port on the
Macintosh. This port has a icon above it. Tighten the
two screws on the sides of the connector.
2. Connect the 50-pin end of the cable to either the top or
bottom SCSI connector of the scanner; then fasten the
connector with the wire clamps on its side.
3. Turn on the scanner, then the Macintosh. (Always turn the
scanner on before the computer.)
4