Husqvarna 96521501 - Manual (Page 27)

27
oPERATIoN
When the engine starts, immediately release the
ignition key back to the run position.
IMPORTANT INFORMATION
Do not run the starter for more than 5 seconds
each time. If the engine does not start, wait
approximately 10 seconds before retrying.
WARNING!
Engine exhaust and certain vehicle
components contain or emit
chemicals considered to cause
cancer, birth defects or other
reproductive system damage. The
engine exhaust contains carbon
monoxide, which is a odorless,
colorless, poisonous gas. Do not use
the machine in enclosed spaces.
8050-780
Turn to the start position
8052-001
Set the engine speed
8050-781
Return to run position
Press in and turn the ignition key to the start position.
Set the desired engine speed with the throttle. Allow
the engine to run at a moderate speed, “half throttle”
for 3-5 minutes before loading it too heavily. USE
FULL THROTTLE WHEN MOWING (no choke).
If your battery is too weak to start the engine, it should
be recharged. (See “Battery” in the Maintenance
Section.)