Husqvarna 96521501 - Manual (Page 30)

30
oPERATIoN
Engage the mower deck by pulling out the blade 6.
switch.
Move throttle control to full throttle.
7.
The machine’s speed and direction are
continuously variable using the two steering
controls. When both controls are in the neutral
position, the machine stands still.
By moving both controls an equal amount forward
or backward, the machine moves in a straight line
forward or backward respectively.
In order, for example, to turn right while moving
forward, move the right control towards the neutral
position. The rotation of the right wheel is reduced
and the machine turns to the right.
Turning on the spot (zero turn) can be achieved
by moving one control backward (behind the
neutral position) and carefully moving the other
steering control forward from its neutral position.
8052-001
Set blade engagement and throttle control
Operating On Hills
Read the Safety Instructions “Driving on Slopes” in the
“Safety Instructions”.
The slowest speed possible should be used •
before starting up or down hills.
Avoid stopping or changing speed on hills.
•
If stopping is absolutely necessary, pull steering •
controls into the neutral position and push to the
outside of the unit. Engage the parking brake.
To restart movement, release the parking brake. •
Pull the control levers back to the center of the •
mower and press forward to regain forward
motion.
Make all turns slowly.
•
IMPORTANT INFORMATION
Control levers return to neutral when released.
This may cause the mower to suddenly stop.
8058-020
Parking brake released
WARNING!
Do not drive up or down hills with
slopes greater than 10 degrees. Do
not drive across slopes.
8061-026
Place controls in neutral position