HP 441877-00F - Manual (Page 27)

Configuration and diagnostics 27
• Invalid adapter device
• Read only bit %s got changed after writing zero at offset 0x%X
• Read only bit %s got changed after writing 1's at offset 0x%X
• Read/Write bit %s did not get cleared after writing zero at offset 0x%X
• Read/Write bit %s did not get set after writing 1's at offset 0x%X
• BIST failed.
• Could not generate interrupt
• Test aborted by user
• Tx DMA:Got 0x%08x @ 0x%08x. Expected 0x%08x
• Rx DMA:Got 0x%08x @ 0x%08x. Expected 0x%08x
• Tx DMA failed
• Rx DMA failed
• Data error, got 0x%08X at 0x%08X, expected 0x%08X
• Second read error, got 0x%08X at 0x%08X, expected 0x%08X
• Failed writing EEPROM at 0x%04X
• Failed reading EEPROM at 0x%04X
• EEPROM data error, got 0x08X at 0x04X, expected 0x%08X
• Cannot open file %s
• Invalid CPU image file %s
• Invalid CPU image size %d
• Cannot allocate memory
• Cannot reset CPU
• Cannot release CPU
• CPU test failed
• Invalid Test Address Range
• Valid adapter address is 0x%08x-0x%08x and exclude 0x%08x-0x%08x
• DMA:Got 0x%08x @ 0x%08x. Expected 0x%08x
• Unsupported PhyId %04X:%04X
• Too many registers specified in the file, max is %d
• Cannot write to VPD memory
• VPD data error, got %08X @ 0x04X, expected %08X
• No good link! Check Loopback plug
• Cannot TX Packet!
• Requested to Tx %d. Only %d is transmitted
• Expected %d packets. Only %d good packets are received
• %d unknown packets have been received