haier HDW100SST - Manual (Page 10)

Lid in detergent compartment cannot be closed
Detergent compartment has been overfilled.
Mechanism is clogged with remnants of detergent.
Remnants of detergent stuck inside dispenser
Compartment was damp when it was filled up with detergent.
Compartment must be dry before detergent is added.
Water remains inside appliance after programme has
ended
Blockage or kind in drainage hose.
Pump is jammed.
Filters are blocked.
The programme is still running. Wait for the programme to end .
...during washing
Unusual amount of foam is creased
Normal washing up liquid has been poured into the rinse-aid
container.
Appliance stops suddenly while washing is taking
place
Cut off electricity supply to appliance.
Water supply has been interrupted.
Knocking sound can be heared while washing is tak-
ing place
A spray arm is knocking against the dishes inside the appliance.
Rattling sound can be heared while washing is taking
place
Crockery has not been stacked properly inside the appliance.
Knocking sound coming from inlet valves
This is caused by the way the water pipes have been laid and
it has no effect upon the way the appliance functions. There is
no remedy for this.
Remove any spilled rinse aid with a cloth as it could otherwise
lead to excessive foaming during the next washing cycle.
...with the dishes,cutlery, etc.
Remnants of food are stuck to the dishes, cutlery,etc.
Dishwasher was not loaded properly. Jets of water could not
reach all parts of the dishes, ect.
Too many items in the rack.
Items in the rack were touching each other.
Not enough detergent was added to dispenser.
Selected wash programme was not intensive enough.
Rotation of spray arm was obstructed by dishes, etc.
Nozzles in spray arm are blokcked by remnants of food.
Filters are blocked.
Filters have been incorrectly fitted.
Waste-water pump is jammed.
Amount of rinse-aid set too high.
Smears left behind on glasses and cutlery; glasses
have acquired a metallic appearance
Unsuitable detergent was used.
Glasses are not dishwasher-proof.
Glasses become clouded and discoloured; coating
cannot be wiped off
Cutlery is not sufficiently rustproof.
Traces of rust on cutlery
Not enough detergent was added to dispenser compartment.
Amount of rinse-aid was set too low.
Although water is quite hard, no salt has been put in appliance.
Water softener was set too low.
If you used a phosphate-free detergent , try a detergent con-
taining phosphates and compare results.
White stains are left on crockery, glasses have a milky
appearance
Not enough detergent was added to dispenser.
Detergent has insuffcient bleaching properties. Use a deter-
gent containing a chemical bleaching agent.
Plastic items are discoloured
Selected programme did not include drying function.
Amount of rinse-aid was set too low.
Items were removed from dishwasher too soon.
Dishes,cultlery,etc.have not been dried
Amount of rinse-aid was set too low.
Glasses have a dull appearance
Detergent does not have a sufficient bleaching effect.
Washing temperature was set too low.
Tea stains or traces of lipstick have not been com-
pletely removed
Troubleshooting
.9.