haier HDW100SST - Manual (Page 11)

fig.2
Installation
Positioning the Appliance
Position the appliance in the desired location. The dishwasher is
equipped with water supply and drain hoses that can be posi-
tioned to the right or left to allow correct installation.
Levelling the Appliance
Once the appliance is positioned, adjust the feet by screwing them
in or out. The appliance should not be inclined more than 2
degrees, to ensure proper performance.
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4 bsp connector
and make sure that it is fastened tightly (see fig.1).
If the water pipes are new or have not been used for an extended
period of time, let the water run first, till it is clear and free of
impurities. Otherwise the water inlet filter may get blocked.
Hot Water Connection
The appliance can also be connected to the house's hot water
supply following the same procedure as for the cold water
connection. Attention:
The plastic hose support must be fastened to the wall to
prevent the drain hose from moving.
Electrical Connection
After making sure that the voltage and frequency in the home
correspond to those on the rating plate of the appliance (located
on the side of the stainless steel inner door) and that the electri-
cal system can cope with the maximum voltage on the rating
plate,insert thr plug into an earthed electrical socket.
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter
of 40mm, or let it run into the sink. Use the plastic support that
comes with the appliance (see fig .2) and ensure there are no
tight bends or kinks. The free end of the hose must be at a height
between 40 and 100 cm and must not be immersed in water.
fig.1
.10.
MAX 100
MIN 40
DO NOT CONNECT TO A PUSH THROUGH HOT WATER
SYSTEM OR ONE THAT EXCEEDS A TEMPERATURE OF
60 O C.
DO NOT USE ADAPTORS OR EXTENSION LEADS.