Hoover 56511A46 - Manual (Page 19)

10
3.4 3.5
attach hose
3.4 Push ON/OFF switch to OFF position.
Remove regular hose from cleaner. Align end of extra
reach hose with projections (J) over slots (K) in dirt duct.
3.5 Slide hose into (K) and twist hose to lock it into place.
(To detach hose, reverse procedure.)
Attach wands or tools to the other end of hose.
*Available at additional cost if not included with your
cleaner.
extra reaCh hose*
K
J
K
CheCk baG indiCator
(Available on select models only)
The indicator (L) will begin to show red as the filter bag fills with dirt. There are three
conditions that will cause the indicator to become completely red:
1. If the bag is full; change the bag.
2. If very fine materials have been picked up, clogging the bag pores; change
the bag.
3. If there is a blockage in the nozzle, hose, tools or at the bag opening;
remove the blockage (see “Clearing blockages” section).
3.6
l
4. MaintenanCe
Check filter bag from time to time. It is recommended
that you change the filter bag when dirt reaches the
dotted line. If more dirt than this accumulates, your
cleaner will not operate effectively.
filter baG:
when to replace CAUTION
! !
Very fine materials, such as face powder or
cornstarch, may seal the filter bag and may cause it
to burst even though it is partially full of dirt. When the
cleaner is used to remove material of this nature,
change filter bag often.
what to buy
Use only genuine HOOVER ® bags with your vacuum.
When purchasing a new bag, ask for HOOVER ®
Allergen Type Y Part no. 4010100Y.
IMPORTANT
All new carpet has loose fibers which can fill the bag
quickly while vacuuming. This type of debris does
not activate the “Check bag” indicator available on
some models.