Grass bag cleaning and replacement, Engine maintenance, Engine oil level check – HONDA HRC216PDA User Manual

Page 11: Engine oil recommendations, Engine oil change, Cap (p. 11), P. 11)

Advertising
background image

11

GRASS BAG CLEANING AND REPLACEMENT

Cleaning

Wash the bag with a garden hose and allow it to dry completely before
use; a wet bag will clog quickly.

Replacement

Replace a worn or damaged bag with a Honda replacement bag or its
equivalent (page 19).

Removal

1. Unclip the plastic edges of the

bag from the frame.

2. Remove the bag from the

frame.

Installation

1. Insert the bag frame into the

bag, as shown.

2. Clip the plastic edges of the

bag onto the frame, as shown.

ENGINE MAINTENANCE

Engine Oil Level Check

1. Unscrew and remove the oil

filler cap/dipstick and wipe it
clean.

2. Insert and remove the dipstick

without screwing it into the
filler neck
. Check the oil level
shown on the dipstick.

3. If the oil level is low, add oil to

reach the upper limit mark on
the dipstick. Do not overfill. If
the engine is overfilled, the
excess oil may get transferred
to the air cleaner housing and
air cleaner filter.

NOTICE

Running the engine with a low
oil level can cause engine
damage. This type of damage
is not covered by the
DISTRIBUTOR’S LIMITED
WARRANTY (page 20).

4. Screw in the oil filler

cap/dipstick securely.

Engine Oil
Recommendations

Always change the oil in
accordance with the
maintenance schedule on
page 9.

Oil is a major factor affecting
performance and service life.
Use 4-stroke automotive
detergent oil.

SAE 10W-30 is recommended for general use. Other viscosities
shown in the chart may be used when the average temperature in
your area is within the recommended range.

The SAE oil viscosity and service category are in the API label on the
oil container. Honda recommends API SERVICE category SJ or later
oil with the ILSAC “starburst” certification mark displayed on the
container.

Engine Oil Change

Drain the used oil while the engine is warm. Warm oil drains quickly
and completely.

1. Turn the fuel valve OFF (page 8). This will reduce the possibility of

fuel leakage.

2. Wipe the oil filler area clean, then remove the oil filler cap/dipstick.

3. Place a suitable container

next to the mower to catch
the used oil, then tilt the
mower on its right side.

The used oil will drain
through the filler neck. Allow
the oil to drain completely.

Please dispose of used
motor oil and the container
in a manner that is
compatible with the environment. We suggest you take it in a
sealed container to your local recycling center or service station for
reclamation. Do not throw it in the trash, pour it on the ground, or
pour it down a drain.

4. Fill with the recommended oil.

Do not overfill. Allow a couple
of minutes for the oil to settle in
the engine, then measure the
oil level as shown under
Engine Oil Level Check.

NOTICE

Using nondetergent oil can
shorten the engine’s service
life, and using 2-stroke oil can
damage the engine.

OIL FILLER CAP/
DIPSTICK

LOWER
LIMIT

UPPER
LIMIT

-20

20 30 40°C

-10 0 10

40 60

100°F

80

0

20

30

5W-30 • 10W-30

Advertising