HONDA HRC216PDA - Manual (Page 3)

3
SAFETY LABEL LOCATIONS
These labels warn you of potential hazards that can cause serious
injury. Read them carefully. If a label comes off or becomes hard to
read, contact an authorized Honda servicing dealer for a replacement.
SETTING UP YOUR
NEW MOWER
Loose Parts
Use the following included loose parts to set up the lawn mower.
Handlebar Setup
1. Pry open the right side handle support hanger, and place it over
the right handle above the starter rope guide. Squeeze the ends
together. Make sure the ribs are facing out, as shown.
2. Slip the left handle support hanger over the end of the handlebar
and slide past both bolt holes. Make sure the ribs are facing out.
3. Position the handlebar onto the handle stay, and loosely install the
two 8 x 16 mm flange bolts through the handlebar lower bolt holes.
DO NOT OPERATE UNLESS GUARD
IS CLOSED OR BAG IS IN PLACE
HOT MUFFLER CAN BURN YOU.
Stay away if engine has been running.
KEEP HANDS and FEET AWAY
Part Quantity
Handle support plate 2
Handle support hanger 2
Flange bolt (8 x 16 mm) 2
Flange bolt (8 x 40 mm)
2
Self-locking nut (8 mm) 6
RIBS
OUT
STARTER ROPE
GUIDE
RIBS OUT
8 x 16 mm
FLANGE BOLT (2)
HANDLE STAY