HP C737990900 - Manual (Page 14)

14 Interface Implementation
Supported Messages
The following messages are supported by the drives:
■ ABORT
■ BUS DEVICE RESET
■ COMMAND COMPLETE
■ DISCONNECT
■ IDENTIFY
■ IGNORE WIDE RESIDUE
■
INITIATOR DETECTED ERROR
■
MESSAGE PARITY ERROR
■ MESSAGE REJECT
■ NO-OP (no operation)
■
RESTORE POINTERS
■
SAVE DATA POINTER
■
Extended Message: PARALLEL PROTOCOL REQUEST
■
Extended Message: SYNCHRONOUS DATA TRANSFER REQUEST
■
Extended Message: WIDE DATA TRANSFER REQUEST
For implementation details on these messages, see Chapter 2, “Messages”
Supported Commands
The following commands are supported by the drives. They include all
Mandatory and Extended commands and most Optional commands.
19h ERASE 57h/17h RELEASE UNIT
12h INQUIRY 03h REQUEST SENSE
1Bh LOAD/UNLOAD 44h REPORT DENSITY SUPPORT
2Bh LOCATE A0h REPORT LUNS
4Ch LOG SELECT 56h/16h RESERVE UNIT
4Dh LOG SENSE 01h REWIND
15h/55h MODE SELECT 1Dh SEND DIAGNOSTIC
1Ah/5Ah MODE SENSE 11h SPACE
1Eh PREVENT/ALLOW MEDIUM REMOVAL 00h TEST UNIT READY
08h READ 13h VERIFY
05h READ BLOCK LIMITS 0Ah WRITE