Horizon Fitness T50 - Manual (Page 5)

BEFORE YOU
BEGIN
ASSEMBL
Y
9
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
TREADMILL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL OPERA
TION
LIMITED
W
ARRANTY
8
DO NOT CUT STRAPS UNTIL STEP 1.4!* Disassemble box and remove the
cardboard packaging that is not beneath the treadmill. Do not attempt to lift the
treadmill at this time. Reach under treadmill running deck to locate parts box.
Remove plastic wrap from console masts.
NOTE:
It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to
prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
Lift LEFT CONSOLE MAST into
upright position. Be sure to hold
the console mast firmly, as it
will not stay in the upright
position on it’s own.
Move LEFT SIDE LINKAGE ARM
into position. Insert TEFLON
WASHER (B) (2 pcs) and BOLT
(A) and tighten.
Repeat on the right side.
Now cut the banding straps and
remove remaining packaging
material.*
ASSEMBLY STEP 1
A
B
C
D
PRE-ASSEMBLY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
* NOTE:
If the straps have been removed before completing
STEP 1, refer to the TROUBLESHOOTING section (page 26)
in order to restore the treadmill to its proper position.
������
������������
����
���������������������
WARNING
A With running deck in lowered
position, place CONSOLE on
upright masts. Slide the brackets
that are underneath the console
handlebars into the top holes of
the upright masts.
B Place BOLT (?) into outside of
LEFT upright MAST and tighten
with NUT (?).
C Repeat on Right Side.
D Place 2 BOLTS (?) into inside of
LEFT upright MAST and tighten.
E Repeat on Right Side.
A Gently lift RIGHT side of the
console to connect the CONSOLE
CABLE. Carefully tuck wires in
mast to avoid damage. NOTE: Do
not pinch console cable or grip
pulse wires.
B Repeat steps 2-3 above to
assemble the right side upright
mast and console.
C Connect power plug to the treadmill
and connect the cord to a power
outlet. The on/off switch is located
next to the power cord. Flip this
switch to the 'on' position, so that
the switch is lit. You will hear a
beep and the console will light up.
ASSEMBLY STEP 2
ASSEMBLY STEP 3
YOU’RE FINISHED!
* Be sure to tighten bolts after all are lined up.
�������
�������������
��������
���������
�������
ASSEMBLED IN STEP 3
T50-T70_Treadmill.indd 8-9 4/21/05 9:03:47 AM