HONDA FG100 - Manual (Page 34)

6. Lift the throttle lever towards the handlebar to
expose the slotted hole.
7. Insert the cylinder end of the throttle cable into
the slotted hole.
8. Release the throttle lever. Swing the cable up
as shown.
Pull on the throttle cable housing so the end
can fit into the throttle lever cable socket.
9. Release the throttle cable into the throttle lever
cable socket.
Squeeze the throttle lever several times to
make sure it operates smoothly and releases
properly.
10. Route the throttle cable and the engine switch
harness behind the handlebars and inside the
lower handlebar as shown.
Remove the small screw which is located just
below the air cleaner cover on the engine
block. Secure the green wire eyelet end to the
engine block as shown.
11. Plug the male connector end of the black wire
into the female connector hanging below the air
cleaner cover.
THROTTLE
CABLE
THROTTLE LEVER
(pull up)
CYLINDER
END
SLOTTED HOLE
THROTTLE
CABLE
HOUSING
THROTTLE LEVER
CABLE SOCKET
Pull throttle cable
housing end. THROTTLE LEVER
(release)
THROTTLE LEVER
CABLE SOCKET
THROTTLE
CABLE
HOUSING
Release the throttle cable
housing into the throttle
lever cable socket.
SMALL
SCREW
BLACK WIRE FEMALE
CONNECTOR BLACK WIRE
MALE
CONNECTOR
GREEN
WIRE
EYELET
TERMINAL
AIR CLEANER
COVER
ASSEMBLY
32
FG100 TILLER