Hitachi 53F300 - Manual (Page 7)

FRONT PANEL CONTROLS
7
FIRST
TIME
USE
INPUT 5
S-VIDEO
VIDEO
-AUDIO-
L/MONO R
EXIT
INPUT
SELECT
MENU MAGIC FOCUS VOL- VOL+ CH- CH+
̈ ̇ ̆ ̄
ቤ ቧ ቢ ባ ብ
ቨ
POWER
PULL
ቦ ቩ
53F300
43F300
S-VIDEO
MAGIC
FOCUS
VIDEO
-AUDIO-
L/MONO R
EXIT
INPUT POWER
Push open door and
pull forward and down
SELECT
MENU
VOL- VOL+
CH-
CH+
ቤ
ቧ
ቦ ባ ቢ ብ
ቨ
ቩ ቪ
ቪ
ቫ
EXIT
INPUT POWER
SELECT
MENU
VOL- VOL+
CH-
CH+
ቢ
MENU/SELECT button
This button allows you to enter the MENU, making it possible to set TV features to your preference without using the remote. This
button also serves as the SELECT button when in MENU mode.
ባ
INPUT/EXIT button
Press this button to select the current antenna source, VIDEO: 1, 2, 3, 4, 5 or alternate antenna source. Your selection is shown in
the top right corner of the screen. This button also serves as the EXIT button when in MENU mode.
ቤ
CHANNEL selector
Press these buttons until the desired channel appears in the top right corner of the TV screen. These buttons also serve as
the cursor down (
̄) and up (̆) buttons when in MENU mode.
ብ
VOLUME level
Press these buttons for your desired sound level. The volume level will be displayed on the TV screen. These buttons also serve
as the cursor left (
̇) and right (̈) buttons when in MENU mode.
ቦ
POWER button
Press this button to turn the TV on or off.
ቧ
MAGIC FOCUS
Use this button to automatically adjust your picture quality to optimum performance (see page 47). The Magic Focus button will not
work when adjustment mode is set to manual (see page 48).
ቨ
FRONT INPUT JACKS (INPUT 5)
Use these audio/video jacks for a quick hook-up from a camcorder or VCR to instantly view your favorite show or new recording.
Press the INPUT button until VIDEO: 5 appears in the top right corner of the TV screen. If you have mono sound, insert the audio
cable into the left audio jack.
ቩ
IR RECEIVER
The IR receiver (remote sensor) of the TV is in the control panel. When using the remote control, point it towards the control panel
for best response.
ቪ
DIMMER SENSOR
The Dimmer Sensor will automatically reduce picture contrast and brightness when viewing in a dark room (see page 35).
ቫ
POWER LIGHT (53F300 only)
You will see a red light when the TV is turned on.
NOTES: Your remote control does not have an INPUT button. To change to video inputs, press VID1~VID5 buttons depending
on your choice (see page 21).
NOTE: For the 43F300 model, the power light is located in the POWER button.