Harbor Freight Tools 97520 User Manual
Page 8
SKU 94481 For technical questions, please call 1-800-444-3353
PAGE 8
3.
While holding the Pusher (63) in place, press the Release (74) and slide the
Pusher forward.
OPERATING THE NAILER
1.
Attach the Nailer to the air supply at the Quick Coupler (83). Start your
compressor and check the pressure, making sure it is set at the recommended
70-120 PSI.
Do not exceed the maximum 120 PSI.
2.
Rotate the Exhaust Cover (2) so that the exhaust air blast will be directed
away from the operator.
3.
To fire, place the Safety (50A) of the Nailer on the workpiece. The Nailer
should not fire if the Safety is not depressed. Once depressed, gently and briefly
squeeze the Trigger (36) once; one Brad will be fired.
4.
Do not press the Safety (50A) against the workpiece with extra force. Allow
the tool to do the work. Always allow the tool to recoil off the work surface.
5.
When finished using the Nailer, always disconnect the tool from its air supply.
Empty the Magazine Assembly (70) completely of Brads. Attempt to fire the
Nailer into a piece of scrap wood to ensure it is disconnected and is incapable of
firing any Brads.
6.
Make sure to store the Nailer in a clean, dry, safe location out of reach of
children.
Trigger (36)
Magazine Assembly
(70)
Safety (50A)
Exhaust Cover
(2)
REV 08g