Hotpoint FDW65 - Manual (Page 17)

17
D ISHWASHER
Fault Area Issue Cause/How to resolve…
Wash cycle indicators lights 4
& 5 flashing (Fast & Prewash).
- Water tap turned off
Indicators 4&5
(Fast & Prewash)
If you are not at your dishwasher when the short beeps
sound, the dishwasher will switch to alarm mode and
indicator lights 4 & 5 (Fast & Prewash) will flash.
Follow the instructions below to cancel:
Step 1:
Turn the dishwasher off by pressing the “On/Off” button.
Step 2:
Turn on the water tap
Step 3:
Wait approximately 20 seconds and then switch the appliance on by
pressing the “On/Off” button.
Step 4:
Select wash programme as normal.
Please Note:
If the above does not solve the problem, check that the
water feed pipe filter is not blocked.
Wash cycle indicator lights
3&5 flashing (Eco& Prewash).
- Possible Filter Blockage
In
Indicators 3 & 5
(Eco & Prewash)
dicators
If wash cycle indicator lights 3 & 5 (Eco & Prewash) are flashing, then
you need to clear the filter of any blockages before programme can proceed.
Step 1: Press the “On/Off Button”, to turn off your dishwasher.
Step 2: Remove filter from base of machine (Fig.1)
Step 3: Rinse filters under running water and ensure that large food
particles are removed from Area A (Fig.2).
Step 4: Locate filters back into the filter housing and firmly press
downwards.
Step 5: Turn the dishwasher on by pressing the “On/Off” button, and
select required programme.
Fig.2
$
For additional advice on Cleaning your filter see “Care
and Cleaning”section of the instruction book.
Fig.1