Hypertec HYNEP61056 - Manual (Page 6)

• Automatic sensing and switching between 10 Mbps or 100 Mbps
operation
•
Full Duplex. Independent receive and transmit circuits allow full duplex
operation at both 10 Mbps and 100 Mbps, allows for maximum throughput of 200
Mbps
•
A single RJ-45 female connector supports both 10 Mbps and 100 Mbps
operation
• Platform independent. Supports all type II CardBus PC Card
compliant PCs
•
Easy installation and configuration
•
Wide Network Operating Systems support (Including Windows 98,
Windows 95, Windows NT, Novell NetWare and more)
• Problem-free upgrade from 10 Mbps to 100 Mbps networks
•
Simultaneous Data/Fax Modem and Ethernet / Fast Ethernet LAN
operation
• Compliant with Advanced Configuration and Power Interface ACPI
• Supports modem speeds of up to 56Kbps
•
International country support - Certified and approved for use
in many countries
• Supports V.90, K56flex*, V.34, V.32 terbo, V.32bis, V.22bis, V.22A/B,
V.23, V.21, Bell 212A and 103J data transmission
•
Video-ready modem interface (VRM) V.80.
•
Flash software upgradeable to future ITU 56K standards
• Supports CCITT V.17, V.29, V.27ter and V.21 ch 2 send and receive
fax transmission (Class 1 & 2)
•
Increased modem throughput with V.42bis and MNP5 data compression
•
Error detection and correction using V.42 LAPM and MNP 2-4 protocol
• Fax/Modem installed as a COM port, runs extended AT command set
• Automatic Modem sleep mode for longer PC battery life
•
16550 UART
• Card and Socket Services support
• Direct Enablers to reduce memory requirements included
• Advanced Wizard Utility for easy, straightforward installation