Set-up, Tools required, Unpacking – HONDA HS520AS User Manual
Page 41: Assembly
39
SET-UP
Tools Required
• 12 mm wrench, 10 mm wrench, and a Phillips-head screwdriver
Unpacking
1. Remove all the cardboard. Inspect the loose parts. Missing parts
may be obtained from a servicing Honda snowthrower dealer.
2. Loosen and remove the curved-head bolt, flange nut and starter
bracket from the lower handlebar. Do not discard the hardware.
Assembly
1. Install the handlebar
with the hardware
shown. Tighten the
flange nuts securely.
Qty.
Description
Part number
4
Curved head bolt 8 x 40 mm
90109-VA4-000
4
Flange nut, 8 mm
94050-08000
4
Curved washer, 9 mm
90501-898-000
3
Phillips head shoulder screw 6 x 12 mm
90142-KG8-000
3
Flange nut, 6 mm
90207-PG6-010
2
Cable tie
8 x 40 mm
CURVED HEAD
BOLT (4)
8 x 40 mm
FLANGE NUT (4)
9 mm CURVED
WASHER (4)
HS520.book Page 39 Monday, May 14, 2001 12:36 PM