HONDA HS520AS - Manual (Page 43)

SET-UP
41
4. Install the discharge chute using the three 6 mm Phillips head
screws and 6 mm self-locking nuts. Make sure the screws go on
the inside and the nuts on the outside. Tighten the nuts securely:
HEX NUT TORQUE: 7 ft-lbs (10 N•m)
Add Oil & Fuel
1. The snowthrower is shipped WITHOUT
OIL in the engine.
2. Add enough of the recommended oil
(page25) to bring the oil level to the top
of the filler hole. Do not overfill.
3. Add regular unleaded fuel to the fuel
tank. The fuel capacity is 0.3 US gallons
(1.3 liters). See pages 22 and 44.
Use the Pre-Delivery Check List
The Pre-Delivery Check List is on the back side of the “Feature Card”
included with the document packet. Review the items on the list and
make sure your snowthrower is properly set-up.
Before Use...
All operators of the snowthrower must read the SNOWTHROWER
SAFETY (page 4), CONTROLS & FEATURES (page 8), and BEFORE
OPERATION (page 11) before using the snowthrower.
PHILLIPS HEAD
SCREW (3)
6 mm NUT (3)
PHILLIPS HEAD
SCREW (3)
6 mm NUT (3)
CHUTE BASE
CHUTE
CORRECTLY
ASSEMBLED
UPPER LIMIT
HS520.book Page 41 Monday, May 14, 2001 12:36 PM