HP 1500 Series - Manual (Page 107)

ENWW Appendix B Specifications and regulatory information 105
FCC regulations
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy. If this equipment is not installed and used in accordance with
the instructions, it may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation; the presence of interference
can be determined by turning the equipment off and on. If this equipment does cause harmful
interference to radio or television communications, the user is encouraged to try to correct the
interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase distance between equipment and receiver.
● Connect equipment to an outlet on a circuit different from that to which the receiver is
located.
● Consult your dealer or an experienced radio/television technician.
Note Any changes or modifications to the printer that are not expressly approved by HP could void the
user’s authority to operate this equipment.
Use of a shielded interface cable is required to comply with the Class B limits of Part 15 of FCC
rules.