Table 3-5. post messages -24 – HP PAVILION NX9005 User Manual

Page 121

Advertising
background image

3-24

Troubleshooting and Diagnostics

Service Manual

The following table lists POST messages and explanations for reported problems If the system fails after
you make changes in BIOS Setup, reset the notebook, enter BIOS Setup, and install the defaults or correct
the error.

Table 3-5 POST Messages

Message

Description

0200 Failure Fixed Disk

Fixed (hard) disk is not working or not configured properly Make sure the hard disk is
installed properly Run BIOS Setup and make sure the hard disk type is correctly identified

0210 Stuck key

Stuck key on keyboard

0211 Keyboard error

Keyboard is not working

0212 Keyboard Controller
Failed

Keyboard controller failed the test Might require replacing the motherboard (contains the
keyboard controller)

0213 Keyboard locked

Unlock key switch Unlock the system to proceed

0220 Monitor type does not
match CMOS—Run SETUP

Monitor type is not correctly identified in BIOS Setup

0230 Shadow RAM Failed at
offset: nnnn

Shadow RAM failed at offset nnnn of the 64k block at which the error was detected

0231 System RAM Failed at
offset: nnnn

System RAM failed at offset nnnn of the 64k block at which the error was detected

0232 Extended RAM Failed at
offset: nnnn

Extended memory is not working or not configured properly at offset nnnn Update to the
latest BIOS version

0250 System battery is dead—
Replace and run SETUP

CMOS clock battery indicator shows that the CMOS battery is dead Connect the AC adapter
for at least 24 hours, and then run BIOS Setup to reconfigure the system

0251 System CMOS checksum
bad—Default configuration
used

System CMOS has been corrupted or modified incorrectly, perhaps by an application that
changes CMOS data In response, the BIOS has installed the default Setup values Use BIOS
Setup to modify these values if needed If the error persists, check the system battery
Connect the AC adapter for at least 24 hours; replace the motherboard

0260 System timer error

Timer test failed Replace the motherboard

0270 Real time clock error

Real-time clock failed the BIOS test Might require replacing the motherboard

0271 Check date and time
settings

BIOS found the date or time to be out of range, and then reset the real-time clock You might
need to use BIOS Setup to reset the legal date

0280 Previous boot
incomplete—Default
configuration used

Previous POST did not complete successfully POST loads default values and offers to run
BIOS Setup If the failure was caused by incorrect values that are not corrected, the next boot
will likely fail This error is cleared the next time the system is booted

0281 Memory Size found by
POST differed from CMOS

Memory size found by POST differed from that specified in CMOS

02B0 Diskette drive A error

Drive A: is present but fails the BIOS POST diskette tests Make sure the drive is defined with
the proper diskette type in BIOS Setup, and that the drive is connected correctly

02B2 Incorrect Drive A type—
run SETUP

Type of floppy drive A: not correctly identified in BIOS Setup

02D0 System cache error—
Cache disabled

RAM cache failed and BIOS disabled the cache May require replacing the motherboard
A disabled cache slows system performance considerably

02F0: CPU ID

CPU socket number for Multi-Processor error

02F4: EISA CMOS Not
Writeable

ServerBIOS2 test error: Cannot write to EISA CMOS

02F5: DMA Test Failed

ServerBIOS2 test error: Cannot write to extended Direct Memory Access (DMA) registers

02F6: Software NMI Failed

ServerBIOS2 test error: Cannot generate software Non-Maskable Interrupt (NMI)

Advertising
This manual is related to the following products: