HP PAVILION NX9005 - Manual (Page 48)

Service Manual Removal and Replacement 2-15
Removing the Speaker Assembly
(User-Replaceable)
NOTE: The following speaker assembly removal procedures apply only to HP Pavilion ze4x00,
HP nx9005 and nx9000, Compaq Evo Notebook N1050v and N1010v, and Compaq Presario 2100 and
1100 Series notebooks. The HP Pavilion ze5x00, HP nx9010 and HP nx9008, and Compaq Presario 2500
Series notebook speakers are integrated into the top case. Refer to the “Removing the Top Case” section
later in this chapter for procedures on removing the top case and speakers on the HP Pavilion ze5x00,
HP nx9010 and HP nx9008, and Compaq Presario 2500 Series notebooks.
Required Equipment
1 Phillips screwdriver
Removal Procedure
1. Unplug the AC adapter, if present, and then remove the battery.
2. Remove the keyboard cover (page 2-13).
3. Remove the M2.5×6.0mm screw that secures the speaker assembly to the top case.
4. Disconnect the 4-wire cable from the switchboard PCA.
Figure 2-11. Removing the Speaker Assembly