Fitting the loop handle, Assembling the angle gear (326ex), Assembling the angle gear (326es) – Husqvarna 326ES User Manual

Page 12: Assembly

Advertising
background image

ASSEMBLY

12 – English

1151020-95 Rev. 2 2008-03-10

Fitting the loop handle

•

Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.

•

Fit the bolt, securing plate and wing nut as shown in
the diagram.

•

Tighten the wing nut.

Assembling the angle gear
(326Ex)

•

Assemble the angle gear back on the suppporting
tube. Turn the blade so that the drive shaft engages in
the angle gear.

•

Position the angle gear so that its slot is aligned with
the line on the supporting tube.

•

Firmly tighten the screw.

Assembling the angle gear
(326ES)

•

Assemble the angle gear back on the suppporting
tube. Turn the blade so that the drive shaft engages in
the angle gear.

•

Tighten the two screws.

Advertising