Husqvarna 326ES - Manual (Page 13)

ASSEMBLY
English – 13 1151020-95 Rev. 2 2008-03-10
Assembling the cutting
equipment
Assembling the blade (326Ex)
Fit the blade as follows:
1 Fit the drive disc (A) on the outgoing shaft. Make sure
that the edge that fits in the hole of the blade is facing
outward.
2 Block the blade rotation by inserting the locking pin in
the hole behind the blade guard engaging it in the
corresponding hole in the drive disc.
3 Fit the blade (B) on the drive disc.
4 Fit the support flange (C). The support flange must be
fitted with its outer edge hard up against the blade.
5 Fit the locking nut (D). CAUTION! The locking nut has
a left-hand thread. Tighten the locking nut to a torque
of 35-50 Nm (3,5-5 kpm).
6 Remove the locking pin.
CAUTION! Do not forget to remove the locking pin before
using the machine.
Assembling the blade (326ES)
Fit the blade as follows:
1 Fit the drive disc (A) on the outgoing shaft. Make sure
that the edge that fits in the hole of the blade is facing
outward.
2 Block the blade rotation by inserting the locking pin in
the hole behind the blade guard engaging it in the
corresponding hole in the drive disc.
3 Fit the blade (B) on the drive disc.
4 Fit the support flange (C). The support flange must be
fitted with its outer edge hard up against the blade.
5 Fit the two washers (D) and the locking screw (E).
6 Tighten the locking screw to a torque of 18-25 Nm
(1,8-2,5 kpm).
7 Remove the locking pin.
CAUTION! Do not forget to remove the locking pin before
using the machine.
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
!
WARNING! Under no circumstances may
the edge cutter blade be used without the
blade guard fitted.
A
B
C
D
E