HP QM2-101 - Manual (Page 10)

9
MSSC, LLC Collinsville, IL USA Tel: 618-343-1006 Fax: 618-343-1016 55899 Rev 18210
www.msscllc.com
a. INK allows you to set the start ink volume (new cartridge 42 ml), indicates ink volume
status and you set the point where the low ink alarm LED lights.
b. PARAMETER, the most commonly used key, you set the print delay in millimeters
(000 – 999), character width in millimeters (02-26), character height in millimeters
(05-13), dot density (1-8), Font (2 to choose from), print direction as viewed from
behind the printer, and the line speed in meters/minute must be entered by user. The
width, density and speed are interrelated. If the settings are not acceptable the QM2 will
not allow you to leave this window. The QM2 indicates which of these three values are
to high or low using arrows to the left of the variable. Use the arrow keys to maneuver
and change the values and the enter key to store changes.
c. DT TUNE, contains additional date formatting options.
d. TOTAL CNT, allows you to reset the total count (photocell trips)
e. INIT DATA, clears the memory of the entire unit.
CAUTION: If you do this you will lose all messages programmed and print
parameter settings.
f. EXTEND, contains advanced setup functions for repeat print, printer setup, and spacing
between lines for two line printing using the function. 2
S