Husqvarna HUV4213 - Manual (Page 30)

Engine Oil
Page 28 2005 HUV4213 Gasoline Vehicle Owner’s Manual
ENGINE OIL AND FILTER CHANGE
Engine oil and oil filter should be changed after the first 100 hours of operation. After that, they should be
changed every 200 hours of operation or annually, whichever comes first.
1. Turn the key switch to the OFF position then remove the key. Place the Forward/Reverse handle in the
NEUTRAL position. Chock the front wheels.
2. Access the engine compartment. See WARNING “For vehicles with cargo beds...” on page 8.
3. Tilt the bed and ensure that the prop rod is properly engaged.
4. Disconnect the battery cables, negative (–) cable first. See WARNING “To avoid unintentionally start-
ing...” on page 10.
5. Position a pan designed for oil changes under the front drain plug (Figure 18).
6. Use a 14 mm socket or box end (do not use an open end) wrench to remove the drain plug, turning it
counterclockwise, and allow the engine oil to drain into the pan.
ý WARNING
• Do not attempt to change engine oil when the engine is hot or even warm. Engine oil can
cause skin burns.
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear rubber
gloves when handling oil drain plug, oil filter, and oil drain pan.
7. Clean the oil drain plug threads with solvent to remove oil and oil residue. Make sure that the compres-
sion washer remains on the drain plug.
8. Use a 14 mm socket or box end (do not use an open end) wrench and replace the front oil drain plug,
turning it clockwise, and tighten to 18 ft-lb (24.4 N·m).
Figure 17 Engine Oil Level Check – HUV4213
full
low
safe
level
level
Oil fill tube is located behind and under passenger seat.
3
1
2
Level Level level