Hunter Fan Illumi-Heat - Manual (Page 3)

4 43533-01 05/28/2008 5 43533-01 05/28/2008
P R E - I N S TA L L AT I O N f o r M u l i t p l e I l l u m i - H e a t
U n i t s i n Yo u r H o m e
Top View of Fixture
If you are going to install more than one Illumi-Heat in your home, then you will need to assign
each unit a its own unique Transmitter / Receiver Code.
1) Looking at the fixture from its top, locate the Receiver, as shown in Figure 1.
Figure 1 - Receiver
2) On the Receiver you will see the four switches that you will use to set the code for the
Transmitter and the Receiver. See Figure 2.
ON DIP
1 2 3 4
ON DIP
1 2 3 4
Figure 2 - Receiver Code Switches
Switches
NOTE - All Switches are
shown in the ON position
ON DIP
1 2 3 4
Receiver
(Bracket cut away
for clarity.)
3) Configure the Receiver Switches to your desired code. Make a note of which Receiver
Switches you turned On and turned Off. NOTE: Make certain each Receiver is assigned a
different code.
4) Remove the Transmitter Battery Compartment door as shown in Figure 3.
Figure 3 - Remove Transmitter Battery Compartment Door
5) For every Receiver Code Switch you turned Off, use a pair of needle-nosed pliers to
carefully remove its corresponding Connector from the Transmitter Terminals. See Figure 4.
For instance, if you turned Off Receiver Switches 1 and 3, then you would remove
Connectors 1 and 3 from the Transmitter.
1 2 3 4
Transmitter Battery
Compartment Door
Transmitter Terminals
Connector
Figure 4 - Transmitter Terminals and Connector
P R E - I N S TA L L AT I O N f o r M u l i t p l e I l l u m i - H e a t
U n i t s i n Yo u r H o m e