Hunter Fan Illumi-Heat - Manual (Page 6)

43533-01 05/28/2008 10 43533-01 05/28/2008 11
I N S TA L L AT I O N
c o n t i n u e d
Figure 11a Figure 11b
9) Position the Finial over the Glass Dome as shown in Figure 12, and twist it clockwise until
tight.
Figure 12 - Install Finial
Heater
Glass Dome
Glass
Finial
8) Position the Glass Dome under the Heater/Light Fixture as shown in Figure 11a. Then,
place the Glass Dome over the Heater/Light Fixture as shown in Figure 11b.
Install Glass Dome
O P E R AT I O N
1) Restore power at the breaker.
2) Install the 12V alkaline battery (included) into the Transmitter.
3) Use the Heater On/Off buttons on the Transmitter to turn the Heater on and off. Use the
Light On/Off buttons to turn the light on and off. See Figure 13.
Technical Support
If you have any additional questions or problems with your Illumi-Heat please call
1-888-830-1326 (in the United States) or 1-866-268-1936 (in Canada), or contact us over
the internet at www.hunterfan.com.
OFF
OFF
ON
ON
HEATER
LIGHT
Figure 13 - Transmitter Buttons
Heater Off Heater On
Light Off Light On
4) Mount the Transmitter Holder over the Illumi-Heat’s wall switch using the the existing wall
plate screws. See Figure 14.
5) The Transmitter can be placed in the Transmitter Holder for convenience or safekeeping.
Figure 14 - Installing Transmitter Holder