Harbor Freight Tools DUAL MIG 93793 User Manual
Page 11
Page 11
For technical questions, please call 1-800-444-3353.
SKU 93793
FIGure c
nut
SpOOl axle
SpOOl
SpOOl clIp
WelDInG
to Install a 10 lb. Wire Spool
Lift the Access Panel (31) of the Welder
1.
to expose the Wire Feed Assembly.
If the 10 lb. Spool Axle is not already
2.
installed: Unscrew and remove the Nut
and Washer. Install the 10 lb. Spool
Axle (13) onto the Shaft, using the spring
underneath and the washer and nut
above.
(See Figure c.)
Remove the Spool Clip (14), if installed.
3.
Install a 10 lb. Spool (not included) onto
the Spool Axle (13),
making sure that
the wire unwinds from the top and the
hole on the spool lines up with the peg
on the Axle.
(See Figure c.)
Attach the Spool Clip (14) to the Axle,
4.
securing it in place.
(See Figure c.)
REV 07j