Harbor Freight Tools DUAL MIG 93793 User Manual
Page 21
Page 21
For technical questions, please call 1-800-444-3353.
SKU 93793
For a narrow weld, you can usually draw the Welding Wire in a steady straight line. This
b.
is called a
“stringer bead”.
For a wider weld, draw the Welding Wire back and forth across the joint in a curve. This
c.
is called a
“weave bead”.
nOte:
19.
If too much current is drawn from the Welder, the internal Thermal Overload
Protector will activate. The Overload Indicator Light (50) will illuminate and the Welder
will automatically turn off. If this happens, turn the Power Switch to its
“OFF” position
and wait 3 to 5 minutes for the unit to cool down.
(See Figure p.)
After a few seconds, stop. Switch off the Welder, and check your progress. Compare
20.
your weld’s appearance with the diagrams and descriptions shown in the “Weld
Diagnosis” section beginning on page 23. After making any necessary adjustments,
continue the weld while carefully following the DUTY CYCLE guidelines.
(See Figure n.)
Welding Instructions continued on page 25.