HONDA Digital Audio System for Honda Motorcycle - Manual (Page 14)

14
TROUBLESHOOTING
MEASURES
Push the POWER button to turn
the power ON.
Raise the volume either on the
amplifier unit or on the portable
audio unit connected to the
digital audio system.
Connect the sub cord securely.
Cancel the MUTE function.
Replace the on-vehicle or the
optional harness fuse.
Consult with your authorized
Honda motorcycle dealer.
Adjust the volume on the
portable audio unit.
Cancel the function.
Move the device emitting
electric waves away from the
digital audio system. Avoid
operating the digital audio
system near the equipment is
emitting electric wave.
Connect the sub cord securely.
Consult with your authorized
Honda motorcycle dealer.
Consult with your authorized
Honda motorcycle dealer.
SYMPTOM POSSIBLE CAUSE
Digital audio system does
not sound or sound level is
low. Power is OFF.
Volume is set at the minimum.
Sub cord is not connected to
the por table audio unit
securely.
Amplifier unit is in MUTE
mode.
Blown fuse.
Amplifier unit or controller is
faulty.
No sound from left or right
speaker.
Sound distorts or the
digital audio system is
disturbed by noises. Input signal is too high.
“ B a s s - e n h a n c e m e n t
function” is set.
Digital audio system is near
a device or equipment that is
emitting electric waves.
Aside from the probable causes listed in the above chart, the portable audio unit connected to
the digital audio system can cause problems. Refer to the Owner’s Manual of the portable
audio unit for further information.
Sub cord is not connected to
the por table audio unit
securely.
Amplifier unit is faulty.
Amplifier unit is faulty. AVC does not function.
Push and hold the MUTE button for approx. 4 seconds with
the power OFF. Check that the POWER light blinks once and
check the AVC for operation again.
(If the POWER light blinks twice, push and hold the MUTE
button for appox. 4 seconds again.)
Untitled-2 11/2/2006, 9:00 AM 14