HONDA Outboard Motor BF2D - Manual (Page 29)

Exposed moving parts can
cause injury.
Do not operate the
outboard motor without
the engine cover.
Use extreme care when
installing the engine
cover.
27
OPERATION
TAKING CARE OF
UNEXPECTED PROBLEMS,
If it was necessary to remove the
emergency stop switch lanyard
from your wrist to perform the
emergency starting procedure, be
sure the lanyard is attached to your
wrist before operating the
outboard motor.
Have your closest authorized
Honda marine dealer check your
recoil starter system and correct
the problem, so you can use the
recoil starter.
The recoil starter assembly (p. )
should be reinstalled after the
recoil starter is working again.
Install the recoil starter assembly
with the engine stopped.
Leave the recoil starter assembly
off, but install the engine cover (p.
).
If the choke was used to start the
engine, return the knob to the
normal operating position as the
engine warms up. Pull the emergency starter rope
slowly until resistance is felt, then
pull briskly.
Keep away from moving parts
while pulling the rope.
If necessary, rewind the rope and
pull again. If the engine does not
start after several attempts, refer to
p.
.
6.
7.
8.
9.
26
5.
13
56
04/03/11 15:41:13 31ZW6601_028