Installation, Power requirements, Installation position – HONDA Outboard Motor BF2D User Manual
Page 19
16.5 in (418 mm)
22.5 in (571 mm)
17
POWER REQUIREMENTS
INSTALLATION POSITION
INSTALLATION
CENTER LINE
T
T
R
R
A
A
N
N
S
S
O
O
M
M
H
H
E
E
I
I
G
G
H
H
T
T
5.9 in (150 mm)
WATER
SURFACE
ANTIVENTILATION PLATE
Correct and secure installation is
essential for safe boating and good
performance. Follow the installation
instructions provided in this manual.
Transom Height
Before installation, check to be sure
that the outboard motor does not
exceed the recommended maximum
horsepower for the boat on which it
is to be installed. Refer to the boat’s
certification plate for recommended
maximum horsepower. If the
certification plate information is not
available, contact the boat dealer or
manufacturer.
For most applications, the outboard
motor should have a horsepower
rating which provides 80% of the
maximum recommended horsepower
for the boat.
The antiventilation plate of the
outboard motor should be 0
2.0
inches below the bottom of the boat.
With the boat in the water and loaded,
the antiventilation plate should be
about 5.9 inches below the surface of
the water.
Type:
S:
L:
Install the outboard motor on the
center of the boat transom.
04/03/11 15:39:36 31ZW6601_018