Husqvarna 225 HBV - Manual (Page 12)

10
– English
17
18
8
9
19
10
DESCRIPTION
Starter device (18)
and starter handle (17)
The starter device is located at the top on the
engine shrouding and engages in the crank shaft
only when the starter handle is pulled.
Fuel cap (8)
Air filter (9)
The fuel cap (14) is located at the top of the engine
shrouding and has a gasket, which prevents fuel
from leaking out.
The air filter consists of foam-rubber filter medium,
integrated in a plastic casing. The air filter should be
cleaned at specific intervals. Otherwise, the power
blower will consume too much fuel, the performance
will be reduced and an oily deposit may form on the
spark plug electrodes.
Choke (10)
Adjusting the carburetor (19)
The choke is located at the top of the engine shroud-
ing and should be used every time the engine is
cold-started. The choke is de-activated automatical-
ly when the throttle trigger is pressed.
There are three adjusting screws for adjusting the
carburetor:
• Low speed jet
• High speed jet
• Adjustment screw for idling
Adjusting the carburetor involves adapting the
engine to local operating conditions, e.g. climate,
altitude, gasoline and type of two-stroke engine oil
used.
For details about carburetor adjustment, see page
18.