Service station procedures – HONDA 2009 Element User Manual

Page 206

Advertising
background image

Opening and Closing the Hood

1. Park the vehicle, and set the

parking brake. Pull the hood
release handle located under the
lower left corner of the dashboard.
The hood will pop up slightly.

2. Put your fingers under the front

edge of the hood near the center.
The hood latch handle is above the

‘‘H’’ logo. Push this handle up to

release it. Lift up the hood.

If the hood latch handle moves
stiffly, or if you can open the hood
without lifting the handle, the
mechanism should be cleaned and
lubricated.

3. Pull the support rod out of its clip

and insert the end into the
designated hole in the hood.

To close the hood, lift it up slightly to
remove the support rod from the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a foot (30 cm) above the
fender, then let it drop. Make sure it
is securely latched.

HOOD RELEASE HANDLE

LATCH

SUPPORT ROD

CLIP

Service Station Procedures

200

Advertising