HP D6028-90004 - Manual (Page 23)

Chapter 3 Hardware Installation and Configuration
17
CAUTION The HP TopTools Remote Control card is sensitive to static
electricity and can easily be damaged by improper handling.
Use of an antistatic service kit, such as 3M
®
8501/8502/8505
or equivalent is recommended.
To mount the battery pack:
1. Place the HP TopTools Remote Control card on a clean non-conductive
surface and disconnect the battery cable from the card.
2. With reference to Figure 3-1, the cooling vents on the battery pack should
be on the same side as the board components. Be sure the battery cable is
situated on the right and can easily reach the battery connector on the
card.
1. Slide battery
onto board
Cooling vents
3. Plug battery
cable into battery
connector.
2. Insert darts
from rear side
of board
Figure 3-1. Connecting the Battery Pack and Cables
3. Make sure that the battery pack is securely mounted to the card using two
of the supplied plastic darts. These must be pressed in from the back (the
circuit side) of the card. The third dart in the package is a spare.
NOTE In case the battery must be removed (for exchange or
replacement), use a screwdriver or a coin to remove the darts.