Connecting the i, C cable to the server – HP D6028-90004 User Manual

Page 25

Advertising
background image

Chapter 3

Hardware Installation and Configuration

19

2. Plug in either end of the I

2

C cable (HP Part Number 5183-6569).

Note: I C cable
end connectors
are identical

2

Figure 3-3: I

2

C cable

Installing the TopTools Remote Control Card in
the Server

The exact procedure for installing the HP TopTools Remote Control PCI card
depends on your particular server model. For specific information about
installing a PCI card in your server, refer to the user guide supplied with your
server. See Appendix D, "Technical Specifications," for information about the
power requirements for HP TopTools Remote Control.

WARNING

Hazardous voltages are present inside the server. Always
disconnect AC power and unplug external connecting cables
from the HP NetServer while working inside the unit. Serious
injury may result if this warning is not observed.

Connecting the I

2

C Cable to the Server

After you have physically installed the HP TopTools Remote Control card into
your server, you must cable the card to the server’s system board. One end of the
supplied I

2

C/IPMB cable should already be connected to the Remote Control

Card (see previous section). Connect the other end to the I

2

C/IPMB connector on

the server.

Advertising