Husqvarna 1365GN - Manual (Page 17)

17
TROUBLESHOOTING
Troubleshooting
Problem
Engine is running, but no AC
output is available.
Engine runs good but bogs down
when loads are connected.
Engine shuts down during
operation.
Engine lacks power.
Cause
1. Circuit breaker is open.
2. Poor connection or defective
cord set.
3. Connected device is bad.
4. Fault in generator.
1. Short circuit in a connected load.
2. Generator is overloaded.
3. Shorted generator circuit.
1. Out of gasoline.
2. Low oil level
Load is too high.
Solution
1. Reset circuit breaker.
2. Check and repair.
3. Connect another device that is in
good condition.
4. Contact local service facility.
1. Disconnect shorted electrical
load.
2. See "Don't Overload Generator".
3. Contact local service facility.
1. Fill fuel tank.
2. Fill crankcase to proper level or
place generator on a level surface.
See "Don't Overload Generator".