HP SAS DL360 - Manual (Page 28)

28 HP ProLiant DL360 Generation 4p Server (SAS Model) User Guide
Installing PCI riser board assembly
CAUTION: To prevent damage to the server or expansion
boards, power down the server and remove all AC power cords before
removing or installing the PCI riser board.
IMPORTANT: Be sure that all DIMM slot latches are closed to provide
adequate clearance before installing the PCI riser board assembly with
a half-length expansion board.
NOTE: If the expansion slot is populated with the standard PCI-X
storage controller card, it should not be converted to PCI Express.
1. Align the PCI riser boards with the corresponding connectors on the system
board and install it into place.
2. Tighten the four PCI riser board assembly thumbscrews.