Husqvarna 11 C - Manual (Page 22)

20
– English
6007-008H
6007-009H
6007-012
DRIVING
3. Select the required cutting height (1-9) with the
cutting height lever.
To obtain a uniform cutting height it is important
that the tyre pressures are equal on both front
wheels 60 kPa (8.5 PSI).
IMPORTANT INFORMATION
The service-life of the drive belts in-
creases considerably if the engine is run
at low speed when engaging the blades.
For this reason do not increase the throt-
tle until the cutting unit has been lowered
to the cutting position.
Mowing pattern
WARNING!
Clear the lawn from stones and
other object which can be thrown
out by the blades.
Cutting tips
• Localise and mark stones and other fixed
objects to avoid collision.
• Start with a high cutting height and reduce down
until the required cutting result are obtained.
• The cutting results are best with a high engine
speed (fast rotating blades) and low driving
speed (slow moving machine). If the grass is not
too high and thick, the driving speed can be
increased without noticeably depreciating the
mowing result.
• The best lawns are achieved if the grass is cut
often. Mowing becomes more uniform and the
grass cuttings become more evenly distributed
over the surface. The total time consumption is
not greater since it is possible to select a higher
driving speed without inferior mowing results.
• Avoid mowing a wet lawn. The mowing results
are inferior since the wheels sink down into the
soft lawn.
• Hose down the cutting unit with water under-
neath each time it is used. Put the cutting unit in
the service position first.
• If you use the BioClip unit it is important to mow
the grass regularly.
4. Push in the lock button on the lift lever and lower
down the cutting unit.