HP L1581A - Manual (Page 10)

10 User’s Guide
Setting Up the Projector
Setting Up the Module
This section describes how to set up the module.
■ “To install the connectivity module” on page 10
■ “To install a CompactFlash wireless card” on page 12
■ “To set up the projector for wired network access” on page 13
■ “To set up the projector for a wireless connection” on page 15
To install the connectivity module
1. Turn off the projector and, after it cools, unplug the power cord.
2. Open the lid 1 , then remove the screw directly behind the back infrared
receiver 2 .
3. Loosen the two thumb screws 3 from the faceplate of the connectivity module.
4. Pull on the two thumb screws until the module releases from the projector 4 .
5. Remove the old connectivity module from the back of the projector and install
the new connectivity module.