Hughes SATELLITE HN9000 - Manual (Page 38)

The browser opens the Installation Parameters screen, which appears within a larger screen
titled Advanced Configuration and Statistics (
Figure 14: Installation Parameters screen on
page 22). The Installation Parameters screen is the first of several screens that appear within
the Advanced Configuration and Statistics screen as you install the modem.
Figure 14: Installation Parameters screen on page 22 is an example, showing the Installation
Parameters screen with parameters entered. You must enter the specific parameters for the
site where you are installing the satellite modem, as listed on the Installation Reference Sheet.
Do not copy parameters from this example.
Figure 14: Installation Parameters screen
Note: On some screens and in some messages you may see the word terminal. This
word refers to the satellite modem.
4. For each of the following parameters, select the value that is listed on the Installation
Reference Sheet:
• Terminal site name – Note that this field is case-sensitive.
• A code – Satellite orbital location. The value 0949505, which corresponds to the orbital
location 94.950° W.
• B code – Antenna size. The B code and C code values are used to ensure that the satellite
modem transmits at the correct maximum power.
•
Antenna size B code
0.74 m 0749
0.98 m 0988
1.2 m 1208
HN9000 Satellite Modem Installation Guide
22
1037576-0001 Revision E
Installing the satellite modem Chapter 3