Harman Stove Company SF2600A - Manual (Page 7)

7
SF2600.
This figure represents the model SF2600 furnace. It’s intention is to
represent the approximate location of the various controls. This draw-
ing may also be used as a reference for wiring and control spacing.
Please note that this drawing is for reference only. Specific installa-
tions will vary.
mounting The blower And Filter box
Position the filter box between the brackets on the rear of the fur-
nace, with the bottom of the box resting on the flange at the bottom of
the furnace. Insert the mounting clips into the bracket slots to secure
the filter box. (see Figure 2) Next, install the blower brackets onto the
blower being sure to install the rubber feet into the brackets. NOTE:
On the SF3500, install the blower mount and blower before the filter
box. All hardware, brackets, etc. for the blower, will be found in the car-
ton with the blower. Next, position the blower in the filter box, centered
behind the inlet hole and allow approximately /8 in. space between
the rear of the furnace and the blower outlet. Now, install the filter rail
onto the filter box. NOTE: The filter rail is best installed on the side
toward the shaker handle, so that any pipes from the hot water coil do
not interfere with filter installation or removal.
NOTE: Before proceeding with the installation of the access door, it is suggested that the wiring be com-
pleted.
The access door is installed by slipping the flange on the bottom of the access door over the bottom rail
of the filter box opening, then push the top of the door against the top of the filter box opening and secure
with a sheet metal screw.
Furnace Installation
Figure 2
Filter box mounting clips
1/8 in. space between
blower and furnace