Hoshizaki SELF-CONTAINED CRESCENT CUBER L1F015102 - Manual (Page 9)

6
II. Installation and Operating Instructions
A. Checks Before Installation
* Visually inspect the exterior of the shipping container, and any severe damage noted
should be reported to the carrier.
IMPORTANT
1. Remove shipping carton, tape(s) and packing. If packing material is left in
the icemaker, it will not work properly.
2. Ensure all components, fasteners and thumbscrews are securely in place.
3. Remove the shipping tapes holding the Door and Separator. See Fig. 1.
1) Remove the panels to prevent damage when installing the icemaker. (See “B. How to
Remove Panels”.)
2) Remove the package containing accessories.
3) Remove the protective plastic film from the panels. If the icemaker is exposed to the
sun or to heat, remove the film after the icemaker cools.
4) Check that refrigerant lines do not rub or touch lines or other surfaces, and that the fan
blade turns freely.
5) Check that the Compressor is snug on all mounting pads.
6) See the Nameplate on the upper part of the Left Side Panel, and check that your voltage
supplied corresponds with the voltage specified on the Nameplate.
B. How to Remove Panels - See Fig. 1
* Louver: Pull the top towards you, and lift off when the Magnet Catches come off
the body.