Hayes Microcomputer Products PC Card - Manual (Page 51)

DIVA T/A PC Card Reference Guide 51
Utility Commands
This section describes the Utility commands.
Command Description
AT$CP=n Enables or disables compression.
n=0
Disable
n=1
Enable (default)
AT$In On Demand SPID Testing (North America
only)
Lets you test SPIDs on demand
n=<SPID Number> Tests the specified
SPID. To perform this test you must be
connected to National ISDN or AT&T 5ESS
Custom interface. The test is only supported
if neither logical channel is initialized
(either with a SPID or in NIT mode). If
required, clear the SPID and disable NIT
mode for both channels, then reset the card.
You can then run two SPID tests (further
tests will be rejected).
n=<blank> Retrieves any AutoSPID data
downloaded from the SPCS during location
detection. Note that this command does not
initiate the AutoSPID procedure; it simply
retrieves historical data.
The following information is retrieved:
SPIDs, DNs, CTs (v=voice, d=data,
p=packet), error code.
Note: If AutoSPID cannot detect DNs and
CTs, these fields will be empty. If an
AutoSPID download has not been
performed, no information will be
retrieved.
AT$VI View initial Profile