Hobart Welding Products SPOOL GUN DP 3035-10 - Manual (Page 18)

OM-230 261 Page 14
SECTION 4 − OPERATION
4-1. Controls
sb5.1* 6/92 − S-0621-C / Ref. 804 695-A / 804 696-A
.
Spool Gun/MIG Gun switch on
Handler 210 must be in Spool
Gun position for spool gun to
operate.
1 Shielding Gas Cylinder
For shielding gas connections, see
welding power source Owner’s
Manual.
2
Valve
Open valve on cylinder just before
welding.
Close valve on cylinder when
finished welding.
3
Spool Gun/MIG Gun Switch
Switch must be set in Spool Gun
position for spool gun to operate.
4
Trigger
Press trigger to energize welding
power source contactor, start
shielding gas flow, and begin wire
feed.
5
Wire Feed Speed Control
Wire feed speed is controlled by
welding power source Wire Speed
control (see welding power source
Owner’s Manual or door chart for
appropriate setting).
6
Voltage Control
Arc voltage is controlled by welding
power source Voltage control (see
welding power source Owner’s
Manual or door chart for
appropriate setting).
.
To purge shielding gas line, set
gun selection switch (item 3) to
the MIG Gun position.Press
spool gun trigger to energize
gas valve. Shielding gas will
flow, but spool gun will not feed
wire. Hold trigger in for several
seconds to purge gas line.
Return gun selection switch to
the Spool Gun position before
welding.
1
2
Spool Gun
MIG Gun 3
4
5 6
ЗЗЗ
ЗЗЗ
ЗЗЗ