Husqvarna 544 93 62-01 - Manual (Page 6)

6 SpeedMill
WHAT IS WHAT
WHAT IS WHAT (PARTS IDENTIFICATION)
A. SpeedMill BLADE GUARD: Designed specifically for
the SpeedMill. One side is open to allow mounting of the
SpeedMill Bowls. Read this Operation Manual for more
information. See SpeedMill Spare Parts List in this docu-
ment for part number.
B. Inner Flange: Used to support Abrasive Blade. See
K750 power cutter Operation Manual for additional instruc-
tions on this item.
C. Blade Arbor Spacer: Used to support Abrasive Blade.
See K750 power cutter Operation Manual for additional
instructions on this item.
D. SpeedMill Hub: Designed specifically for the Speed-
Mill. Acts as an outer flange for the Abrasive Blade, and
a mounting arbor for the SpeedMill Bowls (E, F, G). Read
this Operation Manual for more information. See SpeedMill
Spare Parts List in this document for part number.
E. 200mm (8”) SpeedMill Bowl: Designed specifically
for the SpeedMill. Always install 8” (200mm) Speed-
Mill Bowl before using machine! Use for beveling 8”
(200mm) plastic pipe. Read this Operation Manual for
more information. See SpeedMill Spare Parts List in this
document for part number.
F. 150mm (6”) SpeedMill Bowl: Designed specifically for
the SpeedMill. Use for beveling 6” (150mm) plastic pipe.
Read this Operation Manual for more information. See
SpeedMill Spare Parts List in this document for part num-
ber.
G. 100mm (4”) SpeedMill Bowl: Designed specifically for
the SpeedMill. Use for beveling 4” (100mm) plastic pipe.
Read this Operation Manual for more information. See
SpeedMill Spare Parts List in this document for part num-
ber.
H. SpeedMIll Hub Nut: Designed specifically for the
SpeedMill. Holds SpeedMill Bowls (E, F, G) in position.
Read this Operation Manual for more information. See
SpeedMill Spare Parts List in this document for part num-
ber.
J. Arbor Bolt Washer: Used to hold SpeedMill Hub (D) in
position. See K750 power cutter Operation Manual for ad-
ditional instructions on this item.
K. Arbor Bolt: Used to hold SpeedMill Hub (D) in position.
See K750 power cutter Operation Manual for additional
instructions on this item.
Note: See K750 Power Cutter Operation Manual, and
K750 Spare Parts List for information on any other
parts of this machine. High Speed Abrasive Blade Not
Included.